I'm programming a PLC in zeliosoft 2 using the FBD mode.
I was wondering if anyone knew if it is possible to record the time between two switches being activated and then use that same time as a delay on an output?
If at all possible what would be the best way to go about this? any help would be greatly appreciated. I've been playing around with the timer function blocks but with little success so far.
I was wondering if anyone knew if it is possible to record the time between two switches being activated and then use that same time as a delay on an output?
If at all possible what would be the best way to go about this? any help would be greatly appreciated. I've been playing around with the timer function blocks but with little success so far.