sigmadelta
Member
From the manual:
if you want to re-synchronize all the interfaces:
– First set the CP 1430 TF to STOP using the mode selector.
– Make sure that the correct number of SYNCHRON HDBs are triggered
on the PLC.
– Set the CP 1430 TF to RUN using the mode selector.
if you want to re-synchronize all the interfaces:
– First set the CP 1430 TF to STOP using the mode selector.
– Make sure that the correct number of SYNCHRON HDBs are triggered
on the PLC.
– Set the CP 1430 TF to RUN using the mode selector.