gusterminator
Member
Hi,
I have a 12 lead motor here with un marked leads. I would like to hook the motor up and test but have no idea what coil is what. I Ohm'd the wires and separated my coils 1 to 6. I chose a coil as #1 and #2 and hooked # one wire to + on a 12V battery. I then hooked a Volt meter up to the other sets of coils one at a time while inducing a voltage across #1 and #2. I was only expecting one set of wires to have a higher induced voltage but I got 2. 2 pairs were 0.8V and all the rest of the pairs were 0.2V.
Does this mean my 0.8 pairs are the one side of the delta?
Any help figuring this out much appreciated.
Thanks
I have a 12 lead motor here with un marked leads. I would like to hook the motor up and test but have no idea what coil is what. I Ohm'd the wires and separated my coils 1 to 6. I chose a coil as #1 and #2 and hooked # one wire to + on a 12V battery. I then hooked a Volt meter up to the other sets of coils one at a time while inducing a voltage across #1 and #2. I was only expecting one set of wires to have a higher induced voltage but I got 2. 2 pairs were 0.8V and all the rest of the pairs were 0.2V.
Does this mean my 0.8 pairs are the one side of the delta?
Any help figuring this out much appreciated.
Thanks