NickOkeeffe
Member
Hi everyone/anyone..
I am looking to program an old Square D Sy/Max Model 300 processor with 8 slots of I/O, wondering has anyone had any experience with this in the past as I could probably do with some
I have the cables to communicate and software on it’s way from the US so just been reading through the programming manual ready. I’ve had a PLC engineer to come look the at the PLC in question already but he has had trouble sending over the register data (the ladder sends over fine), I’m thinking that maybe the rack addressing is wrong
If anyone has any advice on this?
Thanks
Nick
I am looking to program an old Square D Sy/Max Model 300 processor with 8 slots of I/O, wondering has anyone had any experience with this in the past as I could probably do with some
I have the cables to communicate and software on it’s way from the US so just been reading through the programming manual ready. I’ve had a PLC engineer to come look the at the PLC in question already but he has had trouble sending over the register data (the ladder sends over fine), I’m thinking that maybe the rack addressing is wrong
If anyone has any advice on this?
Thanks
Nick