James Mcquade
Member
Hi all,
While i am not new to omron, i'm totally new to the analog part and lost.
i have a CJ2M cpu 33.
then there are 4 i/o cards
card 5 is a MAD42 Unit 00
card 6 is an ETN21
my i/o config for the analog card indicates word D20000 as word 0
what i am trying to do is this.
Analog outputs 1 & 2 are enabled. Analog inputs 1 & 3 enabled, 2 & 4 are Disabled
Output 1 is 0-10 volts. Output 2 is 1-5V/4-20ma.
Input 1 is 0-10 volts. input 3 is 1-5v/4-20ma
i need to move 83 decimal (53 hex) to word D20000
i need to move 8457 (2109 hex) to word D20001.
how do i move 8457 (2109 hex) into word D20001? everything when i go online says 083D hex in the bottom.
also, what is the next steps to get the analog card working? i have the mad42 manual, but i'm getting confused.
do i also download and click the the special Unit Setup button?
when i do, i get the error message "Failed to download the Special Unit Setup" and then download failed
thanks in advance,
james
While i am not new to omron, i'm totally new to the analog part and lost.
i have a CJ2M cpu 33.
then there are 4 i/o cards
card 5 is a MAD42 Unit 00
card 6 is an ETN21
my i/o config for the analog card indicates word D20000 as word 0
what i am trying to do is this.
Analog outputs 1 & 2 are enabled. Analog inputs 1 & 3 enabled, 2 & 4 are Disabled
Output 1 is 0-10 volts. Output 2 is 1-5V/4-20ma.
Input 1 is 0-10 volts. input 3 is 1-5v/4-20ma
i need to move 83 decimal (53 hex) to word D20000
i need to move 8457 (2109 hex) to word D20001.
how do i move 8457 (2109 hex) into word D20001? everything when i go online says 083D hex in the bottom.
also, what is the next steps to get the analog card working? i have the mad42 manual, but i'm getting confused.
do i also download and click the the special Unit Setup button?
when i do, i get the error message "Failed to download the Special Unit Setup" and then download failed
thanks in advance,
james