elektrik85
Member
Hello Everyone,
I am a newbie to Allen Bradley Kinetix 300. We are controlling some indexing conveyors over Ethernet/IP. My issue is when one of the drives faults out for whichever reason. You are able to reset it and start it, but about 2 seconds later it loses the enable and the drive stops. No faults on the drive when this happens. You start it again and the same thing happens. The only way to get the drive to work correctly is to cycle the power on it and let it reboot. Any ideas why the drive behaves like this only after a fault was present? Please help.
I am a newbie to Allen Bradley Kinetix 300. We are controlling some indexing conveyors over Ethernet/IP. My issue is when one of the drives faults out for whichever reason. You are able to reset it and start it, but about 2 seconds later it loses the enable and the drive stops. No faults on the drive when this happens. You start it again and the same thing happens. The only way to get the drive to work correctly is to cycle the power on it and let it reboot. Any ideas why the drive behaves like this only after a fault was present? Please help.