Sinamics G120C

userxyz

Member
U
Join Date
May 2002
Location
any
Posts
2,768
Hello,

I have Sinamics G120C connected on profinet. Everything worked fine for several weeks, but now it doesn't run anymore. The ready led was blinking and P0010 is on 3. So the drive goes went into commissioning. Any ideas why this happens ? We tried a basic setup and it fails...
The communication with the drive still works, but we do not get a ready bit in the statusword, it's not EB31 like it should...

My question: Anyone had the same probs with this drive ?

Thanks,
C
 

Similar Topics

M
Siemens Sinamics G120C fixed speed setpoint
Hello, I use a Siemens Sinamics G120C inverter in combination with a S7-1200 cpu. I use the Main Setpoint with the Providrive option and send...
Replies
8
Views
723
mulderm
M
chud
Replacing Sinamics G120C on Profinet
Hi Guys Just wondering if I replace a faulty G120C with new G120C, is there a FDR (Faulty device replacement) option so the new drive will get its...
Replies
3
Views
1,761
chud
chud
U
TIA Portal Sinamics G120C doesn't start
Default factory parameters. Sending 47F. But no action. Speed controller inhibited. Any ideas ?
Replies
3
Views
2,616
userxyz
U
M
sinamics g120c dp
Can I connect my sinamics g120 to simatic manager even without a control unit??
Replies
4
Views
2,363
marco10
M
L
Sinamics G120C configuration help !
hi folks, I have a Sinamics G120C & BOP-2 Anybody experience with this before, help me in configuration setup for 2 wire control with 4-20ma...
Replies
2
Views
1,935
iant
iant
Back
Top Bottom