Ones_Zeros
Member
Hello
I was wondering if someone could give me a good explanation on Data Tables?
Im working in a SLC 500 program and haven't really used it much
all im wanting to do is add some input I/O (Pressure tansmitters) so i can read it back into my HMI software
These transmitters are supposed to be connected to Card 11 - Inputs 1 &2
as you can see by the screen shot bits 1 & 2 are already used on card 11
The entire word is being used (I:11.0 - bits 0-15)
So the way i read it is I:11.1 (I11/16) is the first available input on card 11
would this be input #16
is this right, I think the wiring may be on the wrong input in the PLC
Thanks for the help
I was wondering if someone could give me a good explanation on Data Tables?
Im working in a SLC 500 program and haven't really used it much
all im wanting to do is add some input I/O (Pressure tansmitters) so i can read it back into my HMI software
These transmitters are supposed to be connected to Card 11 - Inputs 1 &2
as you can see by the screen shot bits 1 & 2 are already used on card 11
The entire word is being used (I:11.0 - bits 0-15)
So the way i read it is I:11.1 (I11/16) is the first available input on card 11
would this be input #16
is this right, I think the wiring may be on the wrong input in the PLC
Thanks for the help