Vipa CPU 244 net uploading station to PG/PC

Hello everyone,
How the vipa cpu244 net can be get connected to pgpc by Ethernet.
CPU is getting connected to its process computer but when tried in simatic manager S7 can't able to connect
Can anyone guide me through please

Hello Rajumech1974,
All VIPA partners worldwide offer free technical support. If you don't get an answer here, please look for them in your country (www.vipa.in).
By the way, here is the manual, if you don't have it (http://www.vipa.in/uploads/tx_sbdownloader/hb99e_cpu24x_08-32.pdf).
The final reason why couldn't connect with S7 is because that PLC is an S5 PLC, I believe.
All the best!

Hello ,
I got connected with vipa 244 by winNCS and uploaded the cp143 with file extensions .ncs , is this file is entire plc station with hardware config or only the cp143 parameters.
Can anybody please point it.
Other thing is this cpu244 net 2BT01. Which connects to the computer Programming device but 2BT10 when installed it is going to run mode but no communication is connected.what could be the reason please.
If I transfer the cp143 file from 01 to 10 will it work
Thanks and regards
Raju k