Guys,
I have a Kinetex 5700 2198-D032-ERS3 module with a VLP-B1002M-P Motor That we changed the gearbox from a 40-1 to a 60-1 because of torque issues.
using the same motor we changed the GB. after that I changed the ratio in the Axis to 60-1 and downloaded to PLC. Now the axis says it is not configured and I have checked everything and can't seem to figure why this is happening. When I try to autotune I get the message (Axis Not Configured) and the Safety State is Unknown (No Motion Connection). Any Ideas??
Running RS Studio v30
Thanks,
Eli
I have a Kinetex 5700 2198-D032-ERS3 module with a VLP-B1002M-P Motor That we changed the gearbox from a 40-1 to a 60-1 because of torque issues.
using the same motor we changed the GB. after that I changed the ratio in the Axis to 60-1 and downloaded to PLC. Now the axis says it is not configured and I have checked everything and can't seem to figure why this is happening. When I try to autotune I get the message (Axis Not Configured) and the Safety State is Unknown (No Motion Connection). Any Ideas??
Running RS Studio v30
Thanks,
Eli