eclarkmeyer
Member
We are attempting to communicate to Channel 0 of a SLC505 over our SCADA system. In setting up the port I was puzzled by the system and user settings. Could someone give a brief explanation, the help files don't.
SLC505 - Channel 0 System vs. User?
- Thread starter eclarkmeyer
- Start date
Archie
Member
System mode makes the port respond to the DF1 protocol commands, such as when getting online with RSLogix.
User mode makes it a generic ASCII port that requires ladder logic code to send and receive information.
User mode makes it a generic ASCII port that requires ladder logic code to send and receive information.
eclarkmeyer
Member
OP
thanks
Similar Topics
Hello.
I'm using bootp to set an ip address for a 1747L551 processor.
The bootp program immediately sees the mac id and I am able to enter an...
I am looking at an old program and doing a retrofit on a sorter. Looking at the ethernet interface, see attached pic, I see a path that is =...
hi, is there anyone that already know how to using remoteio. i find a point io 1734 POINT I/O but that is for the controllogix. i looking for...
Setting up a Sick Barcode reader to communicate with the serial port of the SLC.
Getting the barcode in the following format when I scan...
SLC 505s.
iFix 5.1
I need a system so that a coop student canwork on their computer to build a new iFix application, modify screens, and edit...