communication s7 master controllogix slave profibus

jmrcalin

Member
J
Join Date
Sep 2005
Location
barcelona
Posts
27
Hi!
How can I configure a controllogix (SST-PFB-CLX) as slave profibus in a S7 master?
And How can I delete a configuration of card SST-PFB-CLX?
Regards
 

Similar Topics

S
IOLINK Master on EtherCAT Communication
I have an Omron NX PLC NX1p2 which Supports EtherCAT . also I have Balluff BNI00HA Ecat Block(IOlink Master). I have setup communications and...
Replies
0
Views
175
Shivsrikakolum
S
K
Problems with Micro820 communication as Modbus RTU Master
Hi Guys, I am a new member and this is my first post! I have a little PLC experience but it is mostly with siemens logo and using ladder...
Replies
4
Views
959
drbitboy
drbitboy
B
LS Electric (LG) Master K 200H PLC HMI communication
I haven't had anything to do with LG PLCs before, a customer asked to install a HMI on it to display statuses etc. I looked up and seen Schneider...
Replies
5
Views
1,731
I_Automation
I_Automation
M
communication between schnider PRM acting as master and ABB ACH 550 drive acting as s
how data read and write for using schnider PRM and ABB ACH 550
Replies
0
Views
1,233
mohamedsameer
M
C
IQMaster Communication Problem
Hello I have a Electro-Craft IQ-2000 PDM-30 9101-2003 servo driver. My personality module was corrupted as the drive gives Personality Fault...
Replies
4
Views
1,397
cebrax
C
Back
Top Bottom