briancr
Member
Hi All
I have a CPU 314 IFM order number 6ES7 314-5AE10-0AB0. According to the siemens website this module has 16DI, 16DO, 4AI and 1AO.
When I insert it into hardware config and go to object properties it comes up with 20DI, 16DO, 4AI and 1AO.
Now for the strange part. When inserted into hardware config it only shows input address 124...155 and output address 124...155 and no analogue addresses.
I then went online with it and did a station upload and it came up with the same as above.
Am I missing something?
Does anyone have the wiring diagrams of this unit as both the doors have been lost over time. It is the only unit we have of this type and it is the ideal unit for teaching our apprentices.It was found in our dungeon full of dust. I have had a look at the Siemens website but it is not very user friendly
Thanks
Brian
I have a CPU 314 IFM order number 6ES7 314-5AE10-0AB0. According to the siemens website this module has 16DI, 16DO, 4AI and 1AO.
When I insert it into hardware config and go to object properties it comes up with 20DI, 16DO, 4AI and 1AO.
Now for the strange part. When inserted into hardware config it only shows input address 124...155 and output address 124...155 and no analogue addresses.
I then went online with it and did a station upload and it came up with the same as above.
Am I missing something?
Does anyone have the wiring diagrams of this unit as both the doors have been lost over time. It is the only unit we have of this type and it is the ideal unit for teaching our apprentices.It was found in our dungeon full of dust. I have had a look at the Siemens website but it is not very user friendly
Thanks
Brian