jimcav
Member
Is there a touch screen out there that i can pick a CAN driver / protocal and communicate on a CAN network?
Jim Cav
Jim Cav
hmi and CAN network
- Thread starter jimcav
- Start date
BTalbot
Member
Beijer Electronics has both CanOpen and J1939-drivers:
http://www.beijerelectronics.com/
//Supporter
http://www.beijerelectronics.com/
//Supporter
Wonderment
Member
Horner APG products also...these combine HMI, control, networking and I/O into a single compact unit. Models are also available for J1939.
http://www.heapg.com
http://www.heapg.com
bits'bytes
Member
robertkjonesjr
Member
To add...
Unitronics has an all-in-one like Horner: www.unitronics.com
Note the Redlion only supports SDOs, not PDOs, if that matters to you.
Unitronics has an all-in-one like Horner: www.unitronics.com
Note the Redlion only supports SDOs, not PDOs, if that matters to you.
Similar Topics
We are cutting over a PLC5 to ControlLogix and we ran into some issues with the HMI (FTView v10, Network Distributed). We found that after...
I have a brand new AB 1756-L85E, running version 33, that sporadically bumps the programming laptop and the HMI from communicating with it. After...
Hello,
We are looking at a machine upgrade project, for which we will probably use a Do-More BRX PLC + 3 high speed I/O modules, to automate...
Hi,
I have a doubt about the system architecture shows below:
could two master devices install in same profibus network?
Hi,
A customer wan't to connect to my HMI and run VNC on his side, he doesn't however want to connect to my network in the control cabinet.
Is...