arshmanish
Member
all,help me,how to make encoder input programing in CPM2A(OMRON).
encoder programing
- Thread starter arshmanish
- Start date
arshmanish
Member
OP
reply for encoder programming
incremental encoder whose two outputs are input to PLC for positioning of machine
arshmanish
incremental encoder whose two outputs are input to PLC for positioning of machine
arshmanish
first step
1. go to plc setting
2.select high speed counter
3.used high speed counter
4.select counter mode.......
5.download plc setting in program mode
second step
stl program
ld 25313
mov 248 dm0
mov 249 dm1
third step
connect terminal
input 0000 a phase
input 0001 b phase
input 0002 z phase (do not connect)
eliskasim
kluangjohor
1. go to plc setting
2.select high speed counter
3.used high speed counter
4.select counter mode.......
5.download plc setting in program mode
second step
stl program
ld 25313
mov 248 dm0
mov 249 dm1
third step
connect terminal
input 0000 a phase
input 0001 b phase
input 0002 z phase (do not connect)
eliskasim
kluangjohor
Similar Topics
Sorry in advance for the long post, but this requires a little back story.
I work in a facility with a couple hundred VFDs
Most are in a web...
I have an application using an incremental encoder and then I convert it to degree (0-360) using calculation program. For a while, the calculation...
Hi everyone,
This is my first time posting, so please forgive any omissions or mistakes.
I am attempting to control the velocity of a stepper...
Dears,
i am trying to change the series of encoder from A to B, but the program do not has this option (Rslogix5000, 20.06
the old encoder was...
Hi all,
I am working with an incremental encoder (ABZ signals, 360 ppr (so 1440 counts per rev)) to replace the existing "manual" encoder wheel I...