Single tank water level control using CJ1M CPU12
- Thread starter opo_4
- Start date
.The system work like this..
* Set a setpoint for the water level (eg. 200mm).
* Water is pump into the tank.
* The water flow into the tank controlled by flow control (Valtek Flowserve - 3400IQ Digital Positioner).
* The differential pressure sensor checking the water level.
* The flow adjusted to have the same level which set earlier.
* The flow will maintained when it achieved the level needed.
* Set a setpoint for the water level (eg. 200mm).
* Water is pump into the tank.
* The water flow into the tank controlled by flow control (Valtek Flowserve - 3400IQ Digital Positioner).
* The differential pressure sensor checking the water level.
* The flow adjusted to have the same level which set earlier.
* The flow will maintained when it achieved the level needed.
Similar Topics
Why does the controllogix redundancy modules use a single mode fiber vs multimode fiber?
I am converting a SLC 500 to a Compact Logix. I plan on using a Compact Logix 5380 with conversion Kit.
The problem is that the analog input cards...
Hello, friends,
I am trying to upgrade a system that uses an Onrom incremental encoder (E6B2-CWZ6C) connected to a Danfoss VFD (FC360), but now...
Hello,
I am using Unity pro V15. I have Quantum CPU 671 and Ethernet NOE 77101 configured. I have configured IO scanning on NOE.
I have attached...
What would happen if you ran a 60Hz Single Phase Motor on 50Hz supply?
