CCU communication with mitsubishi

sttchui

Member
S
Join Date
Mar 2008
Location
kl
Posts
81
Hi,
Anyone have try to used CCU communication between Keyence touch screen VT-7S to Mitsubishi Q02HCPU??
I have check the Keyence can only have CCU communication with Q series(Q mode). How is the wiring is configure or any manual can help me!
Thank you!
Regard
sttchui
 

Similar Topics

T
TotalFlow RMC, assigning descriptors to I/O points using PCCU?
I can't seem to figure out how to add descriptors to I/O points on an RMC using PCCU. Say, for example, I want to use "Valve_1" as a descriptor...
Replies
0
Views
73
timothy585
T
T
TotalFlow G4 reset to factory default w/o PCCU connection?
I've got a G4(board only)with a MMI port problem. I do not know the IP, but I believe that port works. Is there a way to reset the device to...
Replies
1
Views
554
parky
P
jawolthuis
Need Accu Sort 24i manual and/or software
I have several Accu Sort 24i scanners and was hoping to implement them in a project. But I have not been able to find a manual for the serial pin...
2
Replies
16
Views
6,298
jawolthuis
jawolthuis
G
Simatic Accu
Hi, Can someone provide some information about the ACCU of SIMATIC. I have a list with the bits from the ACCU but I can't find what they...
Replies
4
Views
4,820
gery
G
S
Communication not done between Woodward controller and PhoenixIO
I have Woodward Controller EASYGEN-3500XT and Phoenixcontact make IO CAN-CUPLER part no: 2702230, Analog Input card: 2861412, Analog Output Card ...
Replies
0
Views
20
Sandeep Patel
S
Back
Top Bottom