timothy585
Supporting Member
I can't seem to figure out how to add descriptors to I/O points on an RMC using PCCU.
Say, for example, I want to use "Valve_1" as a descriptor for DO1 (7.68.8). Is there a field somewhere where I can input this? Seems like the columns to the right of the "State" columns would be a perfect location, but that is not an editable field. Can I even add descriptors to physical points, or can I only add descriptors to holding registers? It would sure be nice to open up the program and easily see the I/O assignments...
Say, for example, I want to use "Valve_1" as a descriptor for DO1 (7.68.8). Is there a field somewhere where I can input this? Seems like the columns to the right of the "State" columns would be a perfect location, but that is not an editable field. Can I even add descriptors to physical points, or can I only add descriptors to holding registers? It would sure be nice to open up the program and easily see the I/O assignments...