ML1500 - PV600 via DH485

i am wanting to connect up a ML1500 LSP to a PV600 2711-T6C3L1 with a NET-AIC with the PLC and running a cable from the 6 pin pheonix to one of the two ports on the screen but i don't seam to be able to find a re-wireable connector for the port on the screen, could i just use a normal RJ45 crimp type plug?

anyone any suggestions?

if i remeber it should be the RJ45 port i use on the screen, also what would be the best comms port to use for this on the PLC and the NET-AIC

I have always used two NET-AIC modules when I used the phoenix connector DH485 network to travel long distances or between many nodes. It may not be required in your case, but I haven't used the ML1500 in my own design yet.

i have worked out the length of the run an i can use the 6 pin pheonix to RJ45 10m cable, i am thinking of using 1761-cbl-ap00 to go from my ML1500 to the NET-AIC, the above cable from the screen to the NET-AIC

will this work in this configuration and what about termination resistors are they built into the cable end seen as though you crn't daisey chain from this type of cable

Rob

Bump

The termination resistor is build into the AIC just jumper pins 5 and 6. I don't see any reason why you cannot daisy chain to another panel. See manual below

http://literature.rockwellautomation.com/idc/groups/literature/documents/um/1761-um004_-en-p.pdf