Hello all.
I have a problem when I try to TEST>CONNECT TO PLC, the diagram not appear. What should I do?
For information, I use CP1E-N20 OMRON.
Here I attached the picture.
picture below show the diagram that suppose appear.
Picture below show that the diagram not appear. This is my problem.
Here is my setting. Is it any problem?
Thanks in advance.
I have a problem when I try to TEST>CONNECT TO PLC, the diagram not appear. What should I do?
For information, I use CP1E-N20 OMRON.
Here I attached the picture.
picture below show the diagram that suppose appear.
Picture below show that the diagram not appear. This is my problem.
Here is my setting. Is it any problem?
Thanks in advance.
Last edited: