grnick50
Lifetime Supporting Member
Dear All,
I am building a small project with surplus equipment to perform a simple positioning task. What I wish to do is to connect two Micrologix1000 with a DTAM micro.
The part number for the ML1000 is 1761-L32BWA and for the DTAM is 2707-M232P3.
As the DTAM is discontinued and I have never used before, I need some advise.
I managed to connect to a single ML1000 through a 1761-NET-AIC but I am not sure if I can connect a second ML1000. My feeling is that my DTAM supports only point to point comms, but I would be more confident if someone else confirms it.
Regards
Nik
I am building a small project with surplus equipment to perform a simple positioning task. What I wish to do is to connect two Micrologix1000 with a DTAM micro.
The part number for the ML1000 is 1761-L32BWA and for the DTAM is 2707-M232P3.
As the DTAM is discontinued and I have never used before, I need some advise.
I managed to connect to a single ML1000 through a 1761-NET-AIC but I am not sure if I can connect a second ML1000. My feeling is that my DTAM supports only point to point comms, but I would be more confident if someone else confirms it.
Regards
Nik