AB Micrologix 1000 remote troubleshooting
- Thread starter rusty152
- Start date
Using the information from your previous post.
Are you asking if the ML1000 along with the ENI can be connected wirelessly?
The answer is yes. If the place you are installing the ML1000 has an existing wireless network then you need a wireless bridge to connect the ENI to. I am doing this with a ML1000 over 802.11 G. I am able to upload/download/go online/program over this connection. The gotcha doing it this way is network latency. I had to adjust the OPC server scan rate to 500ms to avoid issues with stale data.
Shawn
Are you asking if the ML1000 along with the ENI can be connected wirelessly?
The answer is yes. If the place you are installing the ML1000 has an existing wireless network then you need a wireless bridge to connect the ENI to. I am doing this with a ML1000 over 802.11 G. I am able to upload/download/go online/program over this connection. The gotcha doing it this way is network latency. I had to adjust the OPC server scan rate to 500ms to avoid issues with stale data.
Shawn
Similar Topics
"Hello! Good day! Excuse me, I have a question regarding the 1761-NET-ENI. RSLinx has already detected it but it's not connecting to the PLC...
Hi all,
We have a very old pit pump system running on Micrologix 1000. Now, whenever there is an alarm for high conductivity, we want that alarm...
Looking at a Micrologix 1000 1761-L32AWA, I tried to connect using the 1761-CBL-PM02 through a Serial to USB converter (This setup was used...
Hello All
I am trying to convert a ML1000 program for use in a ML1400. I didn't create the original program & documentation is non existent...
Hey Folks,
I have a customer with an older machine that is controlled with a MicroLogix 1000. The machine just quit working.
The power light is...
