escoplcguy
Member
Hey guys,
I wanted to see if there was a better way to compare 10 points (or more) using a limit instruction.
I have 10 points of data that get generated and they all need to fall within a bandwith. for example the bandwith or limitations are lets say 1 to 30. i will capture 10 readings and store them to a floating data file. then i want to check all the points agains my bandwith to make sure they all fall within the tolerance. right now i set up 10 different LIM instructions branching them all down to trigger the accept output. just wanted to see if there was a differnt way or better way of doing this?
I wanted to see if there was a better way to compare 10 points (or more) using a limit instruction.
I have 10 points of data that get generated and they all need to fall within a bandwith. for example the bandwith or limitations are lets say 1 to 30. i will capture 10 readings and store them to a floating data file. then i want to check all the points agains my bandwith to make sure they all fall within the tolerance. right now i set up 10 different LIM instructions branching them all down to trigger the accept output. just wanted to see if there was a differnt way or better way of doing this?