Hi,
Today I attempted to set up communication between my Horner SmartMod and XT105 controller, following old instructions I'm unsure if I achieved this.
I followed this manual:
http://www.hornercanada.com/_downloads/RemoteIO/SmartMod/SmartMod_Setup_MAN0922.pdf
To set everything up, but SmartMod's and Modbus' confuse me. My Modbus Control Block is "11, 3, 14, 4, 8, 1259" Then changed the data so that
Baud Rate = 19200
Slave ID= 11
Device Registry = Holding Registries
Length = 4
Based off my MBC did I miss changing something? Does anyone have simple instructions, mainly on hooking it up and initializing it.
Screen shots and/or zip of code can be provided on request.
Thanks for any help,
Gem.
Today I attempted to set up communication between my Horner SmartMod and XT105 controller, following old instructions I'm unsure if I achieved this.
I followed this manual:
http://www.hornercanada.com/_downloads/RemoteIO/SmartMod/SmartMod_Setup_MAN0922.pdf
To set everything up, but SmartMod's and Modbus' confuse me. My Modbus Control Block is "11, 3, 14, 4, 8, 1259" Then changed the data so that
Baud Rate = 19200
Slave ID= 11
Device Registry = Holding Registries
Length = 4
Based off my MBC did I miss changing something? Does anyone have simple instructions, mainly on hooking it up and initializing it.
Screen shots and/or zip of code can be provided on request.
Thanks for any help,
Gem.