Jonas Zimmer
Member
Is there a simple way to monitor if there is a major fault on the plc. Looking at my systems there is no output to our scada system for a major plc fault, which is very flawed as if there is a major plc fault nothing works! There are alarms for just about everything else except that!
Having not programmed these much and only doing minor maintenance could someone point me in the direction of how to monitor for a major fault? It would be helpful if there was a NC contact on the plc I could monitor. I would want NC so it would be fail-safe.
Thanks in advanced.
Having not programmed these much and only doing minor maintenance could someone point me in the direction of how to monitor for a major fault? It would be helpful if there was a NC contact on the plc I could monitor. I would want NC so it would be fail-safe.
Thanks in advanced.
Last edited: