Soggy Canuck
Lifetime Supporting Member
I have a B&R plc containing among other modules three DM476 Output modules. On two of the 476's the "b" red lamp is lit. Does anyone know the significance of this indicator?
b&r fault? lamp
- Thread starter Soggy Canuck
- Start date
http://download.gongkong.com/file/company/brgk/user/en/2005manual.pdf
If B is on and A is off this means that an output is switched on even though no load is connected.
Hope this helps,
If B is on and A is off this means that an output is switched on even though no load is connected.
Hope this helps,
Soggy Canuck
Lifetime Supporting Member
OP
Thank you very much. Working with an old phone with spotty reception and a very small screen. Would have taken me several hours to arrive at this information.
Much appreciated.
Much appreciated.
Similar Topics
Kindly, we have the following configuration fault on a Kinetix 5700 axis. It only appears when we go online on the Plc. We are just starting the...
Have a system that has been running for over a year and all of a sudden getting a ExcessiveVelocityFault on one of the drives when the MSO command...
Hi, Experts:
We have 20 + years old GE PLC series 90-30 stop running (the run led not on and battery led not on) and HMI showing that "PLC has...
Power flex 527 Network based safety drive had faulty and alarm pop up SOS Code internal fault
Unable to set or clear the fault manually or...
Hi hoping someone can assist me with current issue I am experiencing with an ABB drive.
Problem I’m experiencing is a ABB drive supply a large...