harleymc100
Member
Hi guys, newbie question here.
I have my ML1400 Communicating on an Ethernet network (Ch 1 ).
I also have a pH controller that can communicate via RS485. I wanted to read the pH data via 485.
My question is, can i communicate with this device through Ch 2 of the ML ??, as well as using ethernet for my network? ie, at the same time?
I was going to cut up a 1761-CBL-PM02 cable and connect the Txd/Rxd cores.
Thanks!!
I have my ML1400 Communicating on an Ethernet network (Ch 1 ).
I also have a pH controller that can communicate via RS485. I wanted to read the pH data via 485.
My question is, can i communicate with this device through Ch 2 of the ML ??, as well as using ethernet for my network? ie, at the same time?
I was going to cut up a 1761-CBL-PM02 cable and connect the Txd/Rxd cores.
Thanks!!