RBergmann
Member
We use outside contractors at times to support some of our sites. I can successfully access (upload, download, monitor) most of these sites remotely (using cellular modems) except for two that have been accessed and modified by one of our contractors. I’ve had him give me the latest version of RSLogix 5000 and Studio 5000 that he’s using and cannot see a difference based on version numbers of the software. The PLC, in all cases, is a CompactLogix L-16
Vendor’s versions are:
• RSLogix 5000 – Revision 20.03 (CPR9 SR 5)
• Studio 5000 – Revision 21.03 (CPR 9 SR 5.1)
Our versions are:
• RSLogix 5000 – Revision 20.01 (CPR9 SR 5)
• Studio 5000 – Revision 21.00 (CPR 9 SR 5.1)
Are the minor revisions an issue? I have been told they shouldn't be.
When I try an upload the Studio 5000 file, it tries to upload until about 30%. Then I get the following messages:
“Uploading all PLC/SLC tag mapping information”, then
“Tag used as a PLC-5 mapping file not found” and
“Failed to upload PLC file mapping information”
At that point the upload fails. I have attempted this several times and the upload aborts at the same point, with the same messages, each time.
Any help would be appreciated.
Vendor’s versions are:
• RSLogix 5000 – Revision 20.03 (CPR9 SR 5)
• Studio 5000 – Revision 21.03 (CPR 9 SR 5.1)
Our versions are:
• RSLogix 5000 – Revision 20.01 (CPR9 SR 5)
• Studio 5000 – Revision 21.00 (CPR 9 SR 5.1)
Are the minor revisions an issue? I have been told they shouldn't be.
When I try an upload the Studio 5000 file, it tries to upload until about 30%. Then I get the following messages:
“Uploading all PLC/SLC tag mapping information”, then
“Tag used as a PLC-5 mapping file not found” and
“Failed to upload PLC file mapping information”
At that point the upload fails. I have attempted this several times and the upload aborts at the same point, with the same messages, each time.
Any help would be appreciated.