Is there a "right" way to setup messaging between two ML1400 PLC's? Over the years we've done it several slightly different ways and usually get them to work.
We've done timers with the done bit triggering the message, we've had the done bit of one message trigger the next, we've had the error bit in parallel with the done bit, sometimes we use one-shots, and probably a dozen variations.
Does anyone have their tried and true bulletproof method they would like to share?
We've done timers with the done bit triggering the message, we've had the done bit of one message trigger the next, we've had the error bit in parallel with the done bit, sometimes we use one-shots, and probably a dozen variations.
Does anyone have their tried and true bulletproof method they would like to share?