Hello everyone.
I am using date and time via HMI using SFC0.
I added an entry to the PDT: value in the format Date_And_Time.
I added a value in the Temp section: Int format.
I trigger it with the positive edge of a button.
But I added IO Field on HMI Side. Format Type: Date/time
I am using this as Input/Output.
I added the PDT value of SFC0 to IO Field as a tag.
Likewise, I added the Button as Set Bit.
However, I can't run it.
I tried to read with SFC1. There is no problem in reading, but when I want to enter a value, I see a ########### icon in the IO Field. Where do you think I might be going wrong?
I have shared the photos of my project below, can you help me please?
I am using date and time via HMI using SFC0.
I added an entry to the PDT: value in the format Date_And_Time.
I added a value in the Temp section: Int format.
I trigger it with the positive edge of a button.
But I added IO Field on HMI Side. Format Type: Date/time
I am using this as Input/Output.
I added the PDT value of SFC0 to IO Field as a tag.
Likewise, I added the Button as Set Bit.
However, I can't run it.
I tried to read with SFC1. There is no problem in reading, but when I want to enter a value, I see a ########### icon in the IO Field. Where do you think I might be going wrong?
I have shared the photos of my project below, can you help me please?