Hey guys, it's been a little while. I'm having a problem that I can't seem to figure out. I'm using a Helmholz FLEXtra® multiRepeater. 6 way. I connected to one port, a PAS 153 slave plc unit, out to a Yaskawa 1000 VFD. The out of that goes to in the input of another PAS 153 slave plc and, on to another Yaskawa drive. That works fine.
The problem is when I try to continue to another PAS 153, it bus faults the first two. I have triple checked the addresses to make sure of no conflicts. I have checked the address settings in the software to make sure they are set right. Surely I should be able to get more than just those 4 nodes connected to a port on the 6 way repeater??
The problem is when I try to continue to another PAS 153, it bus faults the first two. I have triple checked the addresses to make sure of no conflicts. I have checked the address settings in the software to make sure they are set right. Surely I should be able to get more than just those 4 nodes connected to a port on the 6 way repeater??