Hi all.
I have a project with Omron CJ1M-CPU11's where I need to connect 2 barcode readers to each.
I want to use the P4 BCR camera as it works great scanning at long distances.
However I don't know much about Omron other then connecting and working the basic instructions.
Ask me how to do this with AB and a basic module... no problem.
No better time then the present to learn something new.
I figure I need one CJ1W-SCU21 on each CPU.
Anyone have suggestions/samples of RS232 communication using this module.
---Edit---
I also figure I will need to use the CX protocol to communicate with the cameras via RS232.
---Edit---
Also I need to connect these CPU's to the network, then connect to an OPC application (yet to be written). For this I'm guessing I need to install a CJ1W-ETN21.
Am I correct in this thinking?
Any help is always appreciated.
Adam
I have a project with Omron CJ1M-CPU11's where I need to connect 2 barcode readers to each.
I want to use the P4 BCR camera as it works great scanning at long distances.
However I don't know much about Omron other then connecting and working the basic instructions.
Ask me how to do this with AB and a basic module... no problem.
No better time then the present to learn something new.
I figure I need one CJ1W-SCU21 on each CPU.
Anyone have suggestions/samples of RS232 communication using this module.
---Edit---
I also figure I will need to use the CX protocol to communicate with the cameras via RS232.
---Edit---
Also I need to connect these CPU's to the network, then connect to an OPC application (yet to be written). For this I'm guessing I need to install a CJ1W-ETN21.
Am I correct in this thinking?
Any help is always appreciated.
Adam
Last edited: