alive15
Member
Good morning,
I have a 1756-EN2TR PLC using studio 5000, along with a Kinetix 6500 (2094-EN02D-M01-S0) drive. The PLC commands a certain speed from the drive, but for some reason, it keeps getting halved? This recent issue only popped up today. See picture below, I command a speed of 2.5 inches/sec, but the drive only commands 1.25 inches/sec.
Thanks,
I have a 1756-EN2TR PLC using studio 5000, along with a Kinetix 6500 (2094-EN02D-M01-S0) drive. The PLC commands a certain speed from the drive, but for some reason, it keeps getting halved? This recent issue only popped up today. See picture below, I command a speed of 2.5 inches/sec, but the drive only commands 1.25 inches/sec.
Thanks,