I was working with a couple of AB MicroLogix 1000 plc's on some machines that I was tasked to modify the programming and wiring.
I found that on both of the plc's the terminal screws were very tight.
I do not mean "tight" as if I could not break them loose, but "tight" as in the entire thread. I bent my "free" distibutor mini screwdriver and had to upgrade to my Klien. (does anyone make a mini impact tool?)
Anyway, Is this normal for the 1000's or am I getting weaker in my middle age?
I found that on both of the plc's the terminal screws were very tight.
I do not mean "tight" as if I could not break them loose, but "tight" as in the entire thread. I bent my "free" distibutor mini screwdriver and had to upgrade to my Klien. (does anyone make a mini impact tool?)
Anyway, Is this normal for the 1000's or am I getting weaker in my middle age?