omron communication with PM500
- Thread starter amnart_j
- Start date
I assume you have an SCB card for serial communications. You will require CX-Protocol to write your modbus code and then communications are programmed in the PLC using the PMCR function.
CX-Protocol will allow you to write routines for any serial device.
beerchug
CX-Protocol will allow you to write routines for any serial device.
beerchug
Similar Topics
Hello everyone,
I am trying to change the IP address of the Omron PLC (NJ30-1200) and HMI (NB7W-TW01B) to fetch the network on our network...
I'm hoping someone with experience here can help. I purchased a piece of equipment from a 3rd party vendor. This piece of equipment was...
I'm new to the Omron world and struggling a bit with transferring data from one NJ controller to another. The first thing I want to do is a...
I have a Omron CP1L PLC that I'm having problems communicating with a NS5-SQ11B-V2 Omron HMI through ethernet . I have the exact same set up on...
Hi;
I have a DUPONT brand machine having OMRON PLC CQM1-CPU21-E. I have CX Programmer installed in my Laptop having W1indow10. I want to go...