Steve Crotty
Member
Hi, I have never used the PanelMate Power Pro Software, and I do not have a PanelMate in front of me to test this on. I was hoping that someone could confirm that this logic is correct (I dont want any surprises when I get to site).
I have an air dryer with a run status (000800, and a alarm indication (000801) coming into the PanelMate. I want to change the colour of a status box based on the two addresses.
What i am unsure about is the && (Logical AND) operator. The help is a bit fuzy on how to use it with two bit adresses.
State 1: ([PLC1,800] = 0) && ([PLC1,801] = 0) ---> Red
State 2: ([PLC1,800] = 1) && ([PLC1,801] = 0) ---> Green
State 3: [PLC1,801] = 0 ---> Flashing Red
Thanks,
I have an air dryer with a run status (000800, and a alarm indication (000801) coming into the PanelMate. I want to change the colour of a status box based on the two addresses.
What i am unsure about is the && (Logical AND) operator. The help is a bit fuzy on how to use it with two bit adresses.
State 1: ([PLC1,800] = 0) && ([PLC1,801] = 0) ---> Red
State 2: ([PLC1,800] = 1) && ([PLC1,801] = 0) ---> Green
State 3: [PLC1,801] = 0 ---> Flashing Red
Thanks,