Hi,
I need to test a scanner connected via RS232 / ASCII on a ET200S 1SI CP card. After downloading the hardware configuration I have fault leds on the PM and CP. There isn't any diag info in the hardware config online. Is this because I have to wire 24VDC to the PM modul ? I Guess that is the problem, but I'm not sure.
Kind regards,
Combo
I need to test a scanner connected via RS232 / ASCII on a ET200S 1SI CP card. After downloading the hardware configuration I have fault leds on the PM and CP. There isn't any diag info in the hardware config online. Is this because I have to wire 24VDC to the PM modul ? I Guess that is the problem, but I'm not sure.
Kind regards,
Combo