ArikBY
Member
Hello Everybody
I Have Red Lion G3 HMI which I installed now in TX.
The unit programed in Israel and worked fine.
The problem is, when I came to install my line I hade to change IP to the factory net.
I try to connect to the panle by USB.The PC install the USB driver but when I come to download the project I get error.
I try also trhu Ethernet but same problen.
The unit start and show the screens.
Somebody have the same problem?
I Have Red Lion G3 HMI which I installed now in TX.
The unit programed in Israel and worked fine.
The problem is, when I came to install my line I hade to change IP to the factory net.
I try to connect to the panle by USB.The PC install the USB driver but when I come to download the project I get error.
I try also trhu Ethernet but same problen.
The unit start and show the screens.
Somebody have the same problem?