Good afternoon guys,
Having a little trouble getting my 8 port I/O link master block to communicate with my processor. Its a BNI 006A MB connected though a 8 port tp link switch.
switch is connected to an ent2 rev 5.002. keying disabled. ent2 is in a rack with a l82S. I can ping the MB, I'm also plugged into the switch. I set up the MB as a generic ethernet device, used the manual to set up the correct input and output sizes. installed the EDS as well. the problem I'm seeing is I cant seem to get a real connection to this block, I keep seeing connection timed out flashing in the module fault window.
i know the block is communicating at least to me. not sure where to go from here. any help or ideas is appreciated.
Having a little trouble getting my 8 port I/O link master block to communicate with my processor. Its a BNI 006A MB connected though a 8 port tp link switch.
switch is connected to an ent2 rev 5.002. keying disabled. ent2 is in a rack with a l82S. I can ping the MB, I'm also plugged into the switch. I set up the MB as a generic ethernet device, used the manual to set up the correct input and output sizes. installed the EDS as well. the problem I'm seeing is I cant seem to get a real connection to this block, I keep seeing connection timed out flashing in the module fault window.
i know the block is communicating at least to me. not sure where to go from here. any help or ideas is appreciated.