Bob T. Jones
Member
Yes, there is a two line LCD display on the Danfoss VLT 2010, but it is not working.
And if you like to read rambling details:
The drive powers up, the red fault light is illuminated and the display back light is illuminated but the display segments are gibberish. Because of that, I am very doubtful the software would be able to connect and extract the parameters, but I would like to try.
Our drive is 30 years old and is used in equipment that does limited production twice each year. The VLT 2000 series developed in 1992, according to Danfoss. It was expanded on by the VLT 5000 series in 1995 and superseded by the VLT 2800 series in 1998.
The VLT 2800 manual still refers to Dialog software, so the software apparently lived on with the 2800 series and may be backwards compatible.
And if you like to read rambling details:
The drive powers up, the red fault light is illuminated and the display back light is illuminated but the display segments are gibberish. Because of that, I am very doubtful the software would be able to connect and extract the parameters, but I would like to try.
Our drive is 30 years old and is used in equipment that does limited production twice each year. The VLT 2000 series developed in 1992, according to Danfoss. It was expanded on by the VLT 5000 series in 1995 and superseded by the VLT 2800 series in 1998.
The VLT 2800 manual still refers to Dialog software, so the software apparently lived on with the 2800 series and may be backwards compatible.