Hi everyone.
Well, I'm going to work with the instruction PTO in PLC micrologix 1400 BXB, and I'm using a driver, but I'm not sure how I should do the conection between PLC and driver, because in the group2 (where I have the high speed outputs) there are 2 terminals: com2 and vdc2.
My questions are: vdc2 is 24v and com2 is ground? should I connect both?
and can I use 5v instead 24v?
I supposed that I should connect both and use 24 v. I attach some pictures.
Someone could explain me how to connect them please?
the link of the driver:https://forum.arduino.cc/index.php?action=dlattach;topic=558523.0;attach=266385
Well, I'm going to work with the instruction PTO in PLC micrologix 1400 BXB, and I'm using a driver, but I'm not sure how I should do the conection between PLC and driver, because in the group2 (where I have the high speed outputs) there are 2 terminals: com2 and vdc2.
My questions are: vdc2 is 24v and com2 is ground? should I connect both?
and can I use 5v instead 24v?
I supposed that I should connect both and use 24 v. I attach some pictures.
Someone could explain me how to connect them please?
the link of the driver:https://forum.arduino.cc/index.php?action=dlattach;topic=558523.0;attach=266385