the_msp
Lifetime Supporting Member
I am looking at getting some motion gear for R&D purposes. I have an L18ERM on order already which will be flashed to V30.
Servo drive wise, I'll likely buy something like Kinetix 350 2097-V31PR0-LM, 2nd hand. Being 2nd hand, it might not have the connectors on it so I will add:
2097-CONN1
Includes AC input power (IPD), back-up power (CPD), shunt and DC bus (BC), motor power (MP),
and safe-off (STO) replacement connectors for Kinetix 300/350 drives.
Motor wise I was browsing the AB site and not much the wiser. The VP series "are optimized to run with the Kinetix 5500 and 5700 servo drives" - optimized or exclusively for?
If I know the frame size, where do I go next... do I have to use an AB branded motor?
Servo drive wise, I'll likely buy something like Kinetix 350 2097-V31PR0-LM, 2nd hand. Being 2nd hand, it might not have the connectors on it so I will add:
2097-CONN1
Includes AC input power (IPD), back-up power (CPD), shunt and DC bus (BC), motor power (MP),
and safe-off (STO) replacement connectors for Kinetix 300/350 drives.
Motor wise I was browsing the AB site and not much the wiser. The VP series "are optimized to run with the Kinetix 5500 and 5700 servo drives" - optimized or exclusively for?
If I know the frame size, where do I go next... do I have to use an AB branded motor?