Looking for Ideas for a distributed control system and need to start a 10A Motor (DOL) or Revsing (DOL), would rather have a EthernetIP conncetion to the motor starter rather than having to put in a distributed IO box for DO's and Din's.
In the Past we have done the same with TESYS U over profibus or Modbus. is there a similar product that will allow start stop over either EtherNet IP or EtherCat? Doesn;t need to Schenider.
I could put a VDF on the motor and control that but VDF control on this is not required and being 3phase @ 10A load makes the VFD to large and a bit of overkill and costly
Have 5 Motors to address in this fashion all distributed.
In the Past we have done the same with TESYS U over profibus or Modbus. is there a similar product that will allow start stop over either EtherNet IP or EtherCat? Doesn;t need to Schenider.
I could put a VDF on the motor and control that but VDF control on this is not required and being 3phase @ 10A load makes the VFD to large and a bit of overkill and costly
Have 5 Motors to address in this fashion all distributed.