jimbo3123
Member
Does anyone here have experience with Ethernet Remote IO with GE Fanuc PLCs?
Specifically, I'm trying to set up a PAC Systems PLC with VersaMax remote racks over ethernet. The remote racks have IC200EBI001 ethernet modules.
I have a test setup here, and it's communicating. However, the fault light on the VersaMax is lit, and I can't figure out what I have to do to make it go out.
There are a lot of things to configure under produced and consumed exchanges to make the ethernet communications work. I think I have it set up right (data does transfer to/from the remote rack).
If someone has a working program with similar comms, I'd like to check it out to verify my settings.
Specifically, I'm trying to set up a PAC Systems PLC with VersaMax remote racks over ethernet. The remote racks have IC200EBI001 ethernet modules.
I have a test setup here, and it's communicating. However, the fault light on the VersaMax is lit, and I can't figure out what I have to do to make it go out.
There are a lot of things to configure under produced and consumed exchanges to make the ethernet communications work. I think I have it set up right (data does transfer to/from the remote rack).
If someone has a working program with similar comms, I'd like to check it out to verify my settings.