TemporalDistortion
Member
Hi techsperts!
I was wondering if anyone could help me...
I have a project where I've configured a (Micro850) PLC
as well as a (Powerflex) VSD
They both work fine and coms is 100%
I just cant figure out how to get access to the Powerflex's tags when using Connected Component Workbench!
In older programs you would just select controller tags and all the info would be there! How do I access the control information in CCW?
I've tried looking everywhere and it seems the only place I can see the info is manually under parameters... I need that info in the PLC
Any advice?
(I've attached a Screen capture of the setup)
I was wondering if anyone could help me...
I have a project where I've configured a (Micro850) PLC
as well as a (Powerflex) VSD
They both work fine and coms is 100%
I just cant figure out how to get access to the Powerflex's tags when using Connected Component Workbench!
In older programs you would just select controller tags and all the info would be there! How do I access the control information in CCW?
I've tried looking everywhere and it seems the only place I can see the info is manually under parameters... I need that info in the PLC
Any advice?
(I've attached a Screen capture of the setup)