Marcosbelgo
Member
Hello friends,
I am new with the micrologix and I am having difficulties to thinking what I need to configure to establish communication between MICROLOGIX 1400 and HMI IX-T5F-2 from the Altus. I am triyng make communication throug the channel 2 of PLC with the COMM port of HMI, that is a RS232/485 serial DB9 multiprotocol according to CH2 of PLC. I am using a serial cable DB9 male Female.
I can use any protocol to make this, I choosed the DH-485 because have less configuration parameters.
I have understood that I just have to configure CH2 of PLC on the rslogix 500, according the figure bellow. The configuration of HMI is showned too. What else have to do?
Thanks
I am new with the micrologix and I am having difficulties to thinking what I need to configure to establish communication between MICROLOGIX 1400 and HMI IX-T5F-2 from the Altus. I am triyng make communication throug the channel 2 of PLC with the COMM port of HMI, that is a RS232/485 serial DB9 multiprotocol according to CH2 of PLC. I am using a serial cable DB9 male Female.
I can use any protocol to make this, I choosed the DH-485 because have less configuration parameters.
I have understood that I just have to configure CH2 of PLC on the rslogix 500, according the figure bellow. The configuration of HMI is showned too. What else have to do?
Thanks
Last edited: