toarts
Member
Hello Guys,
Sorry, this is my first time adding/configuring analog input model number 1762-1F4. I am using Micrologix 1400. I added this analog input into I/O configuration and setup all the parameters 0-10V. Since I dont have any sensor to test the analog input, I hooked up a voltage meter into analog input 1 perhaps I can see some values. But I think I am jumping ahead, is there anything else I should look into? also, in what address I should be looking at, supposed everything setup correctly? is it N7 data table hold all analog input?
Thank you so much for help.
Sorry, this is my first time adding/configuring analog input model number 1762-1F4. I am using Micrologix 1400. I added this analog input into I/O configuration and setup all the parameters 0-10V. Since I dont have any sensor to test the analog input, I hooked up a voltage meter into analog input 1 perhaps I can see some values. But I think I am jumping ahead, is there anything else I should look into? also, in what address I should be looking at, supposed everything setup correctly? is it N7 data table hold all analog input?
Thank you so much for help.