I thought it would a simple swap, I connected to NI4 channels to the same channels on the NI8 card and did not add any more input connections, after I did the swap it wasn't reading any of the original inputs, bear in mind I did a channel for channel swap.
I called Rockwell for support and they said the inputs need to be enabled but due to time constraints it was quicker to forget the 8 channel upgrade and just put in a new NI4 card.
Well with connecting channel to channel I thought it would be straight forward but apparently its not.
A/B talked about block transfers and I know nutting about them, but they are all ready there.
Any help would be appreciated. Thank you.
I called Rockwell for support and they said the inputs need to be enabled but due to time constraints it was quicker to forget the 8 channel upgrade and just put in a new NI4 card.
Well with connecting channel to channel I thought it would be straight forward but apparently its not.
A/B talked about block transfers and I know nutting about them, but they are all ready there.
Any help would be appreciated. Thank you.