Hey all,
Specs are:
W7P-64
Studio 5000 V32.02.00
5069-L320ER PLC
5069-IY4 universal analog input in a 5069-AEN2TR.
Problem is trying to configure the module. If you click on any of the input types, I get a Fatal Error in the screen shot.
I've used these in the past with V30 and V31 with no problems.
But, now even in V30 and V31 when I open previous programs, the same thing happens.
The other new bug after this screen shot is even if I click on the channel, like CH00, it goes right to a fatal error and crashes.
Wondering if anyone has run into this?
This system is due to be torn down for shipping in 2 days, so only have till tomorrow to figure it out.
It doesn't matter where the module is located, at the PLC or remote Ethernet adapter. I have another one at the PLC and two others at the Ethernet adapter.
Thanks!
Specs are:
W7P-64
Studio 5000 V32.02.00
5069-L320ER PLC
5069-IY4 universal analog input in a 5069-AEN2TR.
Problem is trying to configure the module. If you click on any of the input types, I get a Fatal Error in the screen shot.
I've used these in the past with V30 and V31 with no problems.
But, now even in V30 and V31 when I open previous programs, the same thing happens.
The other new bug after this screen shot is even if I click on the channel, like CH00, it goes right to a fatal error and crashes.
Wondering if anyone has run into this?
This system is due to be torn down for shipping in 2 days, so only have till tomorrow to figure it out.
It doesn't matter where the module is located, at the PLC or remote Ethernet adapter. I have another one at the PLC and two others at the Ethernet adapter.
Thanks!
Last edited: