drforsythe
Lifetime Supporting Member
I have a fair amount of Logix and Studio experience, but this is my first project with Studio v33 and a 5069 CPU and -IY4 card.
The processor is a 5069-L306ERS2 with firmware 33.015 loaded. Among other cards, I have a 5069-IY4 version 2.012 in the rack. I was able to add the card to the rack configuration and select thermocouple for the appropriate input. The problem I am having is that I cannot change the units from degrees Celsius and I also cannot select a Type J thermocouple. It does not state what type of thermocouple is selected, it simply states that the range is -100mV to 100mV. I cannot change the High or Low Signal or the High or Low Engineering, either. Has anyone seen this? It is not like other analog cards I have set up. I saw some images on the web from v31 or 32 and the configuration interface looks totally different and has settings for different types of thermocouples. If anyone has any insight, I would appreciate your thoughts.
The processor is a 5069-L306ERS2 with firmware 33.015 loaded. Among other cards, I have a 5069-IY4 version 2.012 in the rack. I was able to add the card to the rack configuration and select thermocouple for the appropriate input. The problem I am having is that I cannot change the units from degrees Celsius and I also cannot select a Type J thermocouple. It does not state what type of thermocouple is selected, it simply states that the range is -100mV to 100mV. I cannot change the High or Low Signal or the High or Low Engineering, either. Has anyone seen this? It is not like other analog cards I have set up. I saw some images on the web from v31 or 32 and the configuration interface looks totally different and has settings for different types of thermocouples. If anyone has any insight, I would appreciate your thoughts.